Ovation-software Label Printer Uživatelský manuál stáhnout pdf (Strana 44)

Troubleshooting

36 Ovation2

Printer fails to turn on

• A fuse may be blown, call for service.

• Faulty AC cord.

• A bad power switch may exist on the printer, call for service.

• A faulty AC wall outlet.

Label advances 1-2 inches before a fault indication

• The ribbon is installed incorrectly. Make sure that the dull

side (side with ink) is facing the paper.

• A bad ribbon/paper combination is resulting in an insufficient

amount of friction between paper and ribbon. Ensure that the

correct type of ribbon is being used.

Label advances 12 inches before a fault indication

• The media sensor or media sensor circuitry may be defective,

call for service.

The labels start to print on an angle and the top-of-form is not

able to be sensed, (improper tracking of media)  commonly

seen when switching between various widths of stock.

• The media is not loaded properly, see Section 1.6. When

loading media be certain that the media hub and media guide

are against the media.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 65 66

Žádné komentáře

Ovation-software Label Printer Uživatelský manuál Strana 44